...

Certified Pre-Owned

We at Taylor Upstate know that new isn’t the only option. There are lots of reasons why a preowned machine is the right choice. We also know that there are a lot of nightmares on the open market and internet. That’s why you can put your trust in our Taylor Certified Pre-Owned!  Only an authorized Taylor distributor can offer certified quality pre-owned ice cream machines, frozen beverage and cooking equipment that have being carefully chosen and reconditioned only with Taylor Authorized Genuine Parts.

All our pre-owned ice cream machines, frozen beverage and cooking equipment pass a rigorous diagnostics check and tested by our certified EPA master technicians. Only then after passing our 50 Point Inspection, equipment is approved, prepared and certified to be sold as a Taylor Pre-owned Certified.

Our 50 point inspection and diagnostic check includes:

  • Check condenser fan operation

  • Check / replace water cooled water valves

  • Check beater motor reset buttons

  • Check beater assemblies

  • Check for water leaks

  • Record compressor head pressures

  • Replace dented panels

  • Install new cord

  • Replace cord caps to code

  • Check cycle times

  • Replace hopper gasket

  • Set freezing cylinder temperature

  • Set hopper temperatures per NY health code

  • Set stand-by temperatures per NY health code

  • Check mix indicator lights & sensors

  • Check drive shaft allignment

  • Check / replace freezer door

  • Check / replace draw valves

  • Check / replace prime plugs

  • Adjust set screws for proper overrun

  • Clean condensers

  • Check compressor amperage draws

  • Check beater motor amperage draws

  • Check pulley alignment

  • Replace belts

  • Replace rear shell bearing

  • Install new Tune-up Kit

  • Replace scraper blades

  • Steam clean machine

  • Powder coat frame

  • Adjust draw swithces

  • Set drive couplings

  • Adjust water valves

  • Check / replace contactors

  • Adjust Belts

  • Tighten all electrical connections

  • Clean contacts on all electrical starters

  • Check hopper refrigeration

  • Adjust E.P.R valves

  • Set expansion valves to proper psi

  • Check or change refrigerant

  • Check initial freeze down time

  • Clean or replace casters

  • Inspect or replace pump parts

  • Inspect feed tube

  • Replace air orifice

  • Replace damaged hopper covers

  • Wash & Sanitize all parts

  • Winterize all water cooled units

  • Prepare for storage

Seraphinite AcceleratorOptimized by Seraphinite Accelerator
Turns on site high speed to be attractive for people and search engines.